Tailstock

 The rear back panel is located on the right-hand side of the body, which is on the right-hand side of the operator. The main goal of the individual to head out on a motor-driven lathe is the preservation of the free end of the workpiece during the process. It has also been used for the storage of equipment for the processing of the holes the spiral drills, reamers, and taps (taps and dies). It can be divided into the lathe bed to the elements of a variety of sizes. It is equipped with a set screw, which is the basis for the alignment of the rotation disc. It has a cast iron body, with a hole for the placement of the loosehead, shaft, and the upper part contains a spindle with a single cup of the flywheel and the shaft clamp for attaching to the shaft in the desired position. It's the end of the spindle has a tapered hole for hanging out with the dead-center, taper shank drills, and other tools. The spindle can be moved in and out of the tail of the rod. the rotation of the handwheel, respectively, compared to the anti-clockwise direction. The tip of the rod is the most important part of a lathe. 

There are three kinds of single head is a hydraulically loaded, hydraulic, hydraulic pin. The type of the end of the shaft depends on the model of machines, each one has its function.