In a typical hydraulic system for a mold maker. The ram is powered by a piston in a cylinder is placed at the bottom of the Instagram. High-pressure oil, which is pumped by a gear pump with a plunger. As the piston moves, the ram moves forward, and the oil, on the left-hand side of the cylinder returned to the tank. At the end of a straight run, and the dog gets hit by a car and the shift lever at the other end, which makes it difficult to change its position. Right now, the high-pressure oil is pumped into the left-hand side of the cylinder, which causes the ram to return, and the oil is at the right-hand side is being pumped into the tank at a time. At the end of the battle, the other dog gets to be the reverse lever, which will change the position of the valve, and, therefore, the direction of the effect.
Quick-return motion is caused by the difference in the amount of oil on both sides. The same amount of oil is pumped either to the right or the left-hand side of the cylinder. This leads to an increase of the oil pressure on the left-hand side due to the presence of a connecting rod, and also increases the speed of the return stroke. The length and location of the run, and are regulated by the movement of the dog. The speed can be changed by adjusting the flow of oil through the valve.
The advantages of the hydraulic shaper :
The action of the hydraulic shaper is much smoother than that of a mechanical shaper. The advantages of a hydraulic shaper, are as follows :
1. The speed is almost all of the parking brake is applied, and the total production capacity of
from the cutting tool.
2. Use the slider shifts smoothly and there is less and less inertia of the moving parts.
3. Length of stroke, and can be changed quickly, without stopping the vehicle.
4. Many frequencies are available, and the speed, easy to operate.
5. At a certain speed, you get more beats per minute (bpm).
0 Comments